1315-R2 - Low Viscosity Epoxy Resin
Low Viscosity Epoxy Resin -
Rigid epoxy resin, based on Bis-A with cresyl glycidyl ether. Low viscosity for fast wetting of reinforcement materials with no compromise of HDT. 100% solids, clear, with excellent chemical and corrosion resistance. No VOCs and DOT non-regulated.

Suggested Uses
Hand lay up laminating, vacuum bagging, filament winding, Concrete coatings, general purpose tooling and pattern work.
Properties of Rhino 1315-R2 Epoxy Resin (neat)
Viscosity: | 500 - 700 cps |
EEW: | 182 - 190 |
Color: | 1 (Gardner) |
Weight/Gal: | 9.5 |
Competitive Offsets: | Resolution Epon 813 |
Mixing
Recommend Rhino 1315-R2 be used between 50° – 100°F (product and ambient temperatures). Use below 45°F requires special hardener selection, consult with Rhino sales personnel for low temperature recommendations. Remove all surface contaminates such as water, dirt, rust, and petroleum products. Mold surfaces must be waxed or otherwise “released” prior to epoxy application. All Rhino curing agents are compatible with Rhino 1315-R2 so proportion resin and hardener in accordance with the selected Rhino hardener. Mix resin and hardener for 3 – 5 minutes being certain to scrape the bottom and sides of the mixing container. Mix no material than may be applied before the expiration of the pot life.
Curing
Rhino 1315-R2 cures overnight at typical ambient temperatures (50° – 100°F) with full properties developing in 7 days, see hardener data for specific cure schedules and properties.